We sell replacement motors, bearings, barrels, barrel parts, gaskets and belts.
Lortone Model 3A Rock Tumbler Beltt
Replacement belt for the Lortone 3A tumbler is cheap and easy to replace. With only a phillips head screwdriver you can replace your broken or worn out belt and get back to tumbling.
Rubber Feet for Lortone Bases
A set of four rubber feet for the Lortone 3A tumbler.
Lortone 3A Bearings
This set of Lortone 3A bearings is easy to replace. First remove the belt from the tumbler. Then take off the retaining clip on the drive shaft, remove the pulley, push the shaft into the case, pull out the old bearings, slide in the new bearings, reassemble drive shaft and pulley. For the idler shaft just lift the bearings and shaft up out of their slots, pull off old bearings and replace with new ones.
3A Shaft Retainer Clips
Set of four retainer clips for use on Lortone model 3A. These clips also fit the 33B and 45C rotary rock tumbler shafts.
Lortone 3A Drive Shaft
Lortone 3A replacement drive shaft has the required retainer clip already on it. The new 3A drive shaft does not come with the pulley so you will need to reuse the pulley from the old drive shaft.
Lortone 3A Idler Shaft
The 3A's idler shaft is one of the simplest pieces to replace on the tumbler. Lift the old one out of place, place the used bearings on the new shaft and insert it back into place.
Lortone 3A Barrel Nut and Washer
This is the knurled nut used to tighten the lid on Lortone hobbyist tumbler barrels. Fits all Lortone rock tumbler barrels that we sell.
Does NOT fit Tumble-Bee barrel lids.
Lortone 3A Barrel Drum Boot Gasket
The rubber boot gasket that gives the 3lb barrel a watertight seal.Not designed for Tumble-Bee barrels.
Lortone 3lb Barrel Inner Lid with Stud
The inner metal lid with threaded stud for the Lortone 3A tumbler barrel. Nut and washer are not included.
Lortone 3A Barrel Outer Lid
This is the outer metal lid for a Lortone model 3A 3-pound barrel.
Lortone 3A Barrel
This is a 3-pound barrel that fits the Lortone Model 3A rock tumbler. It is a complete barrel with all of the components.
Barrel Dimensions in Inches
Outside height does NOT include 5/8 inch for the nut and washer.
Lortone Model 3A Tumbler Motor
Replacing your 3A rock tumbler motor is easy and will take just a few minutes. This is a small rock tumbler motor that is designed for Lortone's Models 3A, 33B and, 45C rock tumblers only.